CLR 3080 / CLH 6372

General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372

CLR 3507 / CLH 6230

A semi-flexible, 100% solid, epoxy system. This product was specifically developed for potting / casting of electrical and electronic components. The long pot life of the material makes it suitable for large mass castings or heat induced curing with minimal stress. Product passes UL94-HB in-house flammability testing. For a more rigid system, CLR 3517 / CLH 6230 is recommended. CLR 3507 / CLH 6230

CLR 3516 / CLH 6230

Room temperature cure, filled, semi-flexible epoxy system. Long pot life material is suitable for large mass casting or heat-induced curing with minimal stress. This product was specifically developed for potting / casting of electrical and electronic components. The long pot life of the material makes it suitable for large mass castings or heat induced curing with minimal stress. For a softer system, CLR 3506 / CLH 6230 is recommended. CLR 3516 / CLH 6230

CLS 9600

High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600

XPD 1401 / CLI 4182

Density = 0.80. A low viscosity, low density, user-friendly, room temperature cure, MDI based polyurethane system. The product cures to a hardness of 60 shore A, and has a cured density of 0.80 gms/cm3. XPD 1401 / CLI 4182

XRD 1014 / XHD 1015

High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015

XRD 1018 / XHD 1019

1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019

XRD 1321 / CLH 5185

Machine dispense friendly, tough, casting epoxy system. Increased flexibility when compared to CLR 1831 family. A two component, low stress, heat cure epoxy system specifically developed for use on instrument and power transformers. The product if filled with non-abrasive fillers, making the product suitable for machine dispensing. The cured material exhibits excellent thermal stability and thermal cycling endurance. Product meets UL 94-HB flammability requirements. XRD 1321 / CLH 5185